Winch · 3,000 litres
539 → 57 ppm
of water
The hydraulic oil was loaded with water and dirt. The oil was no good.
After 30 days it was fit again. The unit paid for itself on the first day: replacing those litres cost more.
Official distribution
It removes particles, water and varnish from oil and diesel, with the machinery running. No spinning parts, and little maintenance.
Official distributors of C.C. Jensen, Denmark. We install on board and stay on for the service.
The oil does not have to be changed. It has to be cleaned.
On diesel, this is the circuit.




Fine dust the in-line filter lets through. It wears pumps, gears and injectors.
It gets in through seals and breathers. It corrodes and feeds bacteria in thrusters and stern tubes.
A product of degraded oil. It attacks metal surfaces.
It sticks to valves and controls. The hydraulics go slow or seize.
On a fishing vessel: engine oil, diesel, hydraulic oil for cranes, winches and hatch covers, gearboxes, thrusters and stern tubes. According to C.C. Jensen, 80% of oil-related failures come from contaminated oil.
Against the centrifuge
The 97% figure is from C.C. Jensen, also published by MAN PrimeServ. It compares the power use of an engine-oil centrifuge with that of the offline filter.
Cases on fishing vessels
Winch · 3,000 litres
539 → 57 ppm
of water
The hydraulic oil was loaded with water and dirt. The oil was no good.
After 30 days it was fit again. The unit paid for itself on the first day: replacing those litres cost more.
Engine diesel
18 months
without stoppages
The engine kept failing on contaminated fuel.
Since the CJC filter was installed, no stoppages. Filtration was added to the engine oil and the hydraulic oil: more than a year and a half without failures. The owner said the fuel had never been that clean.
Seawater in the hydraulic oil
20 litres
in 3 days
Seawater got into the oil, in the middle of the fishing season.
In three days about 20 litres came out. In the same situation, another vessel finished the whole season without stopping or going to dock.
Winch, after a breakdown
920,000 → 46,000
particles
A failure had put particles into 3,000 litres. The plan was to dump the oil.
It was saved. Water dropped from 306 to 72 ppm and the offline filter paid for itself in a day. It was then fitted on the controllable-pitch propeller, the generators and the gearboxes.
On hydraulic systems with metal, sand, plastic, varnish and water — up to six times above the acceptable level — the oil came in under ISO 17/15/12. The deposit on the valves and in the tank came off too. According to C.C. Jensen, component life can be multiplied by up to ten.
Installed units
Which unit
Engine oil, hydraulics and gearboxes. Fine particles, varnish and oxidation.
Diesel and hydraulics with water. It filters and separates free water.
Stern tube and thrusters. It removes emulsified water, including in biodegradable oils.
MAN PrimeServ supplies the CJC filter for engine lube oil, as an alternative to the centrifuge.
We take a sample before the filter and another after, and send them to the laboratory. You see the result in the report, with the ISO 4406 code, free of charge, no obligation.
Request an analysis